Honeywell MetroSelect Eclipse MS 5145 - Scan Engine Configuration; IS4125;IS4225 Scan Engine Settings

21–1
IS4125 and IS4225 Scan Engines
³ 1 2 0 3 1 5
Disable Old Serial Program
³ 1 2 0 3 0 5
Enable Old Serial Program
³ 1 2 0 3 1 1
Enable TTL UART
³ 1 2 0 3 1 2
Enable Non Buffered TTL UART
³ 1 2 0 3 1 3
Enable Detect and Notify Mode
³ 8 4 6 6 0 1 1 0
Cunningham Defaults – Scan this code
followed by Recall Defaults code to enable and
load Cunningham defaults.
³ 9 9 9 9 9 8
Recall Defaults
For Same Symbol Time Out information, see page 7–3.
21