Honeywell MetroSelect Eclipse MS 5145 - Scanner Operation and Features; Configuration Mode Options; Scan Buffers and Redundant Scans

7–1
Scanner Operation
Configuration Mode Options
³ 1 1 8 1 1 7
Allow Configuration Mode on Power Up – The
scanner can only enter MetroSet mode before
any bar codes are scanned.
³ 1 1 8 1 0 7
* Allow Configuration Mode Anytime – Allow
MetroSet configuration at any time.
³ 1 1 8 1 1 6
Allow configuration Codes on Power Up
–
Once a product bar code is scanned after power-
up, the scanner will not accept configuration bar
codes.
³ 1 1 8 1 0 6
* Allow Configuration Codes Anytime – Allows
scanning of configuration bar codes at any time.
Scan Buffers
³ 3 1 8 0 0 0
* 1 Scan Buffer – The scanner will scan one bar
code in the scan field and not scan again until
the bar code is removed from the scan field for
the duration of the same symbol time out.
³ 3 1 8 0 1 0
2 Scan Buffers – The scanner will scan two bar
codes in the scan field one time each. These two
bar codes will not be scanned again and until
they are removed from the scan field for the
duration of the same symbol time out.
³ 3 1 8 0 2 0
3 Scan Buffers – Same function as 2 Scan
Buffers, but three bar codes are in the scan field.
³ 3 1 8 0 3 0
4 Scan Buffers – Same function as 2 Scan
Buffers, but four bar codes are in the scan field.
7