Honeywell MetroSelect Eclipse MS 5145 - User Configurable Suffixes, All Data

8–9
User Configurable Suffixes, All Data
Note: Scan the Enter/Exit Configuration mode code before trying to set this
feature. Refer to Multi-Code Method on page 1–1.
³ 9 0 4 5 0 0
~ Configurable Suffix Character #1 – A suffix ID
can be added and assigned for data
transmission. Use this code with a 3 code byte
sequence, on page 16–
1, which represents the
desired character.
³ 9 0 4 6 0 0
~ Configurable Suffix Character #2 – Assigns a
second configurable suffix character.
³ 9 0 4 7 0 0
~ Configurable Suffix Character #3
– Assigns a
third configurable suffix character.
³ 9 0 4 8 0 0
~ Configurable Suffix Character #4 – Assigns a
fourth configurable suffix character.
³ 9 0 4 9 0 0
~ Configurable Suffix Character #5 – Assigns a
fifth configurable suffix character.
³ 9 0 5 0 0 0
~ Configurable Suffix Character #6 – Assigns a
sixth configurable suffix character.
³ 9 0 5 1 0 0
~ Configurable Suffix Character #7 – Assigns a
seventh configurable suffix character.
³ 9 0 5 2 0 0
~ Configured Suffix Character #8 – Assigns an
eighth configurable suffix character.
³ 9 0 5 3 0 0
~ Configurable Suffix Character #9
– Assigns a
ninth configurable suffix character.
³ 9 0 5 4 0 0
~ Configurable Suffix Character #10 – Assigns a
tenth configurable suffix character.
³ 9 9 9 9 8 4
* Clear All User Configurable Suffixes