Honeywell MetroSelect Eclipse MS 5145 - Page 38

7–5
³ 1 1 8 4 1 7
Beep on BEL Command – The scanner beeps
when it receives a BEL character from the host. If
a number is sent within 200 msecs before the
BEL character, the scanner will beep that
number of times.
³ 1 1 8 4 0 7
* Ignore BEL Command
³ 1 1 6 9 1 3
Enable Light Pen Toggle During Beep –
The scanner beeps and toggles the light pen
data line on a successful decode. This drives a
good read indicator.
³ 1 1 6 9 0 3
* Disable Light Pen Toggle During Beep
³ 1 2 4 7 1 1
Enable Pass-Through
³ 1 2 4 7 0 1
Disable Pass-Through
³ 1 2 5 0 1 1
Beep with Pass-Through Data
³ 1 2 5 0 0 1
* No Beep with Pass-Through Data
³ 1 2 5 0 1 0
Enable Record Count Capture
³ 1 2 5 0 0 0
* No Record Count Capture
³ 9 9 8 0 5 2
Transmit Record Counts