Honeywell MetroSelect Eclipse MS 5145 - Page 97

19–2
³ 8 1 9 5 1 2 0
Sleep in 2 Minutes – The scanner will go into
sleep mode after the laser has been off for
2 minutes.
³ 8 1 9 5 3 0 0
Sleep in 5 Minutes – The scanner will go into
sleep mode after the laser has been off for
5 minutes.
³ 8 1 9 5 6 0 0
Sleep in 10 Minutes – The scanner will go into
sleep mode after the laser has been off for
10 minutes.
³ 1 2 3 9 0 7
* Enable Scanning in Cradle
³ 1 2 3 9 1 7
Disable Scanning in Cradle
³ 1 2 3 7 1 1
Enable In Stand Error Audio Indicator
–
Activates an audible indicator the when the
scanner is in the stand/charging cradle but is not
making contact via the battery terminal contacts.
³ 1 2 3 7 0 1
* Disable In Stand Error Indicator
³ 1 2 3 7 0 2
* Enable Cradle LED
³ 1 2 3 7 1 2
Disable Cradle LED
³ 1 2 3 7 0 7
Enable Range Gate – Store scanned bar codes
into RAM if the wireless connection has been
interrupted.
³ 1 2 3 7 1 7
* Disable Range Gate
³ 1 2 3 7 1 6
Enable BT Test – The cradle will display certain
connection information (KO, OK, etc.).
Note: Do not enable this feature unless
instructed
to by a Honeywell representative.
³ 1 2 3 7 0 6
* Disable BT Test