43-TV-25-30 Iss.6 GLO Aug 07 UK 113
Screen Menu
Screen Setup
(Main Menu > Configure > Setup > Edit Setup> Screen)
Set up the recorder’s screen configuration.
• Screen Saver - In this menu you can configure the Screen Saver functions. See
“Screen Saver” on page 113
• Charts - In this menu you can set the Fast, Medium and Slow chart speeds. See
“Charts” on page 114
• Brightness - Adjust the brightness of the screen using the instant brightness slider.
See “Brightness” on page 115
When the configuration is complete select the Finish button to Commit, Discard or Commit
Later. Select the Back button to return to the previous menu.
Screen Saver
(Main Menu > Configure > Setup > Edit Setup> Screen > Screen Saver)
Configure the screen display and Screen Saver functions. The default state for the Screen
Saver is disabled. The Screen Saver function helps to reduce backlight wear. When active,
the back light is off and nothing on the display is visible. The screen saver will not function
in Setup Menus or in test mode.
• Enabled - Toggle On and Off.
• Timeout - Only available when the Screen Saver function is active. This is how long the
Screen Saver will display on the screen. Programmable between 1 and 720 minutes in
software, when disabled the screen will remain on permanently (enter 0 to disable).
• Saver Type - Only available when the Screen Saver function is active. This is set to
Normal.
• Dim Saver - Only available when the Screen Saver function is active. Dim Saver will
help to increase the life of the backlight and lower the screen brightness for night time
use. Use Saver Brightness or Off Always.
To Next Page
Loading...
Need help?
General
