Honeywell N4680 - Page 218

198 N4680 2D Decoded Scan Engine User Guide
Matrix 2 of 5 Message Length Minimum (1 - 80) *4 X25MIN## 102
Maximum (1 - 80) *80 X25MAX## 102
Matrix 2 of 5 Redundancy Range (0-10) *0 X25VOT## 102
Code 11 Default All Code 11
Settings
C11DFT 102
*Off C11ENA0 102
On C11ENA1 102
Code 11 Check Digits Required 1 Check Digit C11CK20 103
*2 Check Digits C11CK21 103
Code 11 Message Length Minimum (1 - 80) *4 C11MIN## 103
Maximum (1 - 80) *80 C11MAX## 103
Code 11 Redundancy Range (0-10) *0 C11VOT## 103
Code 128 Default All Code 128
Settings
128DFT 104
Off 128ENA0 104
*On 128ENA1 104
ISBT Concatenation *Off ISBENA0 104
On ISBENA1 104
Code 128 Message Length Minimum (0 - 80) *0 128MIN## 105
Maximum (0 - 90) *80 128MAX## 105
Code 128 Append *On 128APP1 105
Off 128APP0 105
Code 128 Code Page Code 128 Code Page (*2) 128DCP## 105
Code 128 Redundancy Range (0-10) *0 128VOT## 106
GS1-128 Default All GS1-128 Settings GS1DFT 106
*On GS1ENA1 106
Off GS1ENA0 106
GS1-128 Message Length Minimum (1 - 80) *1 GS1MIN 106
Maximum (0 - 80) *80 GS1MAX 106
GS1-128 Redundancy Range (0-10) *0 GS1VOT## 107
Telepen Default All Telepen
Settings
TELDFT 107
*Off TELENA0 107
On TELENA1 107
Telepen Output *AIM Telepen Output TELOLD0 107
Original Telepen Output TELOLD1 107
Telepen Message Length Minimum (1 - 60) *1 TELMIN## 108
Maximum (1 - 60) *60 TELMAX## 108
Selection
Setting
* Indicates default
Serial Command
# Indicates a
numeric entry
Page