Honeywell Vertex M - Diagnostics

5.6.4 Diagnostics
Use the Diagnostics Window to review operational settings and information about either an
individual analyzer or the Vertex M system. To open the Diagnostics Window, touch Menu and
then Diagnostics.
System Information - Displays the profile ID number, Profile name and other critical system
information.
The Profile ID is a unique number generated whenever the Vertex M Profile Management utility
saves a configuration file. Vertex M stores the ID number in the DAq, the PLC and each
analyzer. If the profile ID numbers do not match, a fault is generated and monitoring will not
start.
Choose the analyzer from the selection pad in the upper right-hand corner. Analyzer
Information lists the following:
l
Profile ID - The Profile ID is a unique number generated whenever the Vertex M Profile
Management utility saves a configuration file. Vertex M stores the ID number in the DAq, the
PLC and each analyzer. If the profile ID numbers do not match, a fault is generated and
monitoring will not start.
l
Gas family information
l
Network IP address
l
Analyzer software version number
l
Analyzer Serial Number
l
Time remaining on filter
l
Time remaining on Chemcassette™ tape
l
Data logging settings for the analyzer
l
Pyrolyzer analyzers will also display the pyrolyzer temperature.
Vertex M 109 User Manual