CHAPTER
5
OPERATION
5.1 Introduction
This chapter describes Vertex M operation including monitoring, system control and data
viewing.
This chapter includes the following sections:
l
Monitoring Mode Overview
l
Main Screen
l
Project Functions
l
Review Functions
l
Menu Buttons
l
OnScreen Keyboard
See "Startup" on page47 if the analyzers in the Vertex M system have not yet been configured.
5.2 Monitoring Mode Overview
Monitor mode is the Vertex M system’s standard operating state. Upon power up, the monitor
performs initialization routines and returns to the same state as when powered down. During
monitoring, the Vertex M system will calculate concentrations every second for each of the
enabled points. Concentrations are used for:
l
Triggering alarm relays
l
Viewing in the main screen
l
Entries in the event list
l
Viewing in point detail screen
Vertex M 80 User Manual
To Next Page
Loading...
