6.5.1 Remove Filters
Figure 6-5. Pyrolyzer Filter Door
Figure 6-6. Vertex M Pyrolyzer Filter
1. Open filter compartment by pulling handle down until door is at a 90˚ angle to the
analyzer.
2. Remove filter magazine by grasping the magazine with thumb and middle finger and
pulling straight out.
Load Filters in Magazine
1. Remove and discard used filter elements.
2. Position new filters in magazine such that the long nipples are up and press into place.
Note direction of flow arrows.
Vertex M 128 User Manual
To Next Page
Loading...
