Honeywell Vertex M - Chapter 4 - Startup; Initial Startup; Factory Configuration; Getting Started

CHAPTER
4
STARTUP
This section describes the Vertex M system startup sequence.
4.1 Initial Startup
Use this section to turn on the Vertex M system and to configure the analyzer modules for
specific gas locations. There are six parts to this startup procedure:
l
Verify Installation
l
Power Up
l
Start Program
l
Configuration Utility
l
Load Tape
l
Leak Checking Sample Lines
l
Verify Flow Rates and Supply Vacuum
4.1.1 Factory Configuration
Honeywell loads all software on the DAq at the factory. The Universal Chemcassette™ Analyzers
are configured for the mineral acid family of gases and the Pyrolyzer Analyzers for NF
3
. Each
point for the target gases needs to be configured at the facility.
4.2 Getting Started
Before startup and configuration, gather the following information:
l
The location to which each point is connected
l
Target gas at each location
l
Alarm levels
l
Relay configuration
Vertex M 47 User Manual