Honeywell Vertex M - Configure PLC

4.6.7 Configure PLC
Use Configure PLC to enter the following:
l
The number of relay cards installed.
l
The number of contacts per card.
l
The number of relays designated as fault relays.
PLC Relay Cards
Up to 4 relay cards populate the Series 1 Vertex M System. The cards are numbered 3-6. In case
of Series 3 Vertex M System, up to 8 cards can be populated and the cards are numbered 2-9.
Relays per Card
Relays are located on relay cards; either 4, 8 or 16 relays populate each card.
l
Cards with 16 relays share a common connection among groups of eight contacts.
l
Cards with 8 relays have 8 isolated pairs of contacts.
l
Cards with 4 relays have 4 isolated pairs of contacts.
Vertex M 68 User Manual