Honeywell Vertex M - Wiring Alarm Relays; Relay Contacts; Wiring Guidelines

3.8 Wiring Alarm Relays
This section describes relay:
l
Contacts
l
Ratings
l
Wiring guidelines
WARNING
Use caution when servicing the PLC terminal blocks. Power to contacts is supplied
externally. See "Series 1 Rack Optional Relay Specifications" on page182 for alarm
relay voltage and contact rating guidelines.
3.8.1 Relay Contacts
The Vertex M system has form-A, single-pole, single- throw relays that activate external alarm
devices. Contacts are available for each circuit to accommodate installation of external devices.
Relay panels are located behind theVertex M LCD screen. See "Series 1 Rack Optional Relay
Specifications" on page182 for more information.
3.8.2 Wiring Guidelines
To wire the alarm relays:
l
Use agency approved wire (such as NRTL in the U.S.) with 300 volt insulation.
Vertex M 45 User Manual