Honeywell Vertex M - OPC Interface

LEDLabel Indication Meaning
GW Status
Green Communication running
Red Communication error
Flashing Network Interface Error
MS
Green Initialized
Green (flashing) Waiting for initialization
Red Major fault, unrecoverable
Red (flashing) Minor fault, recoverable
Ch. A and Ch. B
Off Module not initialized
Red Major fault
Red (flashing) Node configuration error
Red/Green (alternating) Hardware self test
Ch. A or Ch. B
Off Channel disabled
Green Normal operation
Green (flashing) Temporary error or not configured
Red (flashing) No other nodes or media fault
Red/Green (alternating)
MO
Off No connection has been opened
Green A connection has been opened
Table 8.18
8.8.9 OPC Interface
The Vertex M presents the gas alarm, fault status and gas concentration using OPC interface.
The OPC services by FactoryTalk Linx Gateway are automatically initialized at startup of the
application, enabling the Vertex M to act as an OPC Server. The user may connect to the
Network interface Cards RJ45 Port at the rear of the data Acquisition System. See "Data
Acquisition Computer (rear)" on page19 for more information. The Vertex M contains 1331
OPC tags as listed in Table 8-7. Tag Names. Many of these are present for historical reasons
and have low utility for an external HMI system. The column “recommended for most HMI
systems” is provided to help separate the useful from the obscure. The number of
recommended tags is 317.
Vertex M 244 User Manual