Honeywell Vertex M - Default Relay Assignments

For more information see Allen-Bradley publication 1746-2.35. This can be found at:
http://literature. rockwellautomation.com/idc/groups/literature/ documents/td/1746-td006_-
en-p.pdf.
8.5.3 Default Relay Assignments
Note: User is required to setup the relay configuration. The default settings do not include any
faults or alarm levels.
Introduction
By default, the Vertex M reserves the first 2 contacts for faults. Any remaining relay contacts
may be associated with points in any analyzer. See "Set Analyzer Window" on page59 for
procedures to associate relay contacts with alarms.
Main PLC
Vertex M 183 User Manual