Honeywell Vertex M - Operational Description

The only software configuration needed is to load the PLC program (VertexM AnalogOut
Rack2.rss) into the Secondary PLC 5/03 processor. The software required to load this is
RSLogix 500 and RSLinx.
Once the PLC program has been loaded, the standard RS232 port will be configured for
communication with the Prosoft DF1 module and will not support the standard COM port
connection for programming. Any subsequent attempts to load the PLC (either to restore
factory default or load program revisions) will require following a procedure to clear the PLC
memory or communication through the DH485 port. Connecting to this port requires a special
adaptor (1747-UIC) and cable (1747-C13). Contact Honeywell Service for assistance.
8.9.4 Operational Description
The analog outputs on the secondary PLC will mirror the corresponding Fieldbus concentration
register as defined in "Data Values Common to Fieldbus Networks" on page198 in
Concentrations. This section fully describes the outputs under normal operating conditions.
The following table describes the outputs including some additional error states.
Condition Channel Output Notes
Normal
Concentration
Value or 2 mA
fault indicator
See "Data Values Common to Fieldbus Networks" on
page198in Concentrations 2ma fault indicator must be
enabled and is off by default.
Primary
PLC Failure
1 mA on all
channels
Including PLC faulted or in program mode
Com
Failure
1 mA on all
channels
Communication link failure between Primary and Secondary
PLC’s
Secondary
PLC Failure
0 mA on all
channels
Including PLC faulted or in program mode
Channel mapping is defined by the following Table 8-19.
Vertex M Point Secondary PLC Slot AO Channel on Card
1-1-1 Slot 1 Ch. 0
1-1-2 Slot 1 Ch. 1
1-1-3 Slot 1 Ch. 2
1-1-4 Slot 1 Ch. 3
1-1-5 Slot 2 Ch. 0
1-1-6 Slot 2 Ch. 1
1-1-7 Slot 2 Ch. 2
1-1-8 Slot 2 Ch. 3
Vertex M 260 User Manual