4.5 Start Program
Upon power-up, the DAq automatically starts Windows and loads the Vertex M program. After a
few minutes of the startup sequence, the Vertex M main screen opens.
Note: Any time the Vertex M system is powered up, loss of communications may cause
maintenance faults.
See "Event List" on page100 for instructions to clear faults.
Note: Use the Windows Date/Time Properties dialog box to change the time zone, time and date
on the Vertex M system. Stop project if adjusting time and time zone. Once complete, restart
project. See "Stopping Project" on page91 for more information on how to stop the project.
CAUTION
Do not change language in Windows setup. The language must be set to English for
the HMI to function properly.
Figure 4-1. Vertex M Main Screen
Vertex M 50 User Manual
To Next Page
Loading...
