Honeywell Vertex M - Modbus;Tcp; Profibus - DP; Profinet

8.8.3 Profibus - DP
Profibus is a vendor-independent, open fieldbus standard for a wide range of applications in
manufacturing and process automation. Vendor independence and openness are ensured by
the international standards EN 50170, EN 50254 and IEC 61158. Profibus allows
communication between devices of different manufacturers without any special interface
adjustment. Use of special Profibus media is required. For more information about Profibus,
visit www.profibus.com.
Technical information on the gateway which is used in the Vertex M is available from
www.anybus.com.
The Profibus interface uses a DB-9 connector with the standard pinout which is listed in Table
8.12
Pin Function
1 not used
2 not used
3 Line B
4 RTS
5 GND Bus
6 +5 V Bus Out
7 not used
8 Line A
9 not used
Housing PE
Table 8.12
8.8.4 Profinet
PROFINET integrates systems and equipment while bringing the richness of Ethernet to the
factory floor. For more information see https://us.profinet.com/technology/profinet/. Technical
information on the ABC4013 Communicator which is used in the Vertex M is available at
www.anybus.com. Commissioning a Profinet network requires Proneta or similar software tool.
The memory size is padded to 256 bytes with bytes 244 to 255 all zero.
8.8.5 Modbus/TCP
Modbus/TCP provides highly reliable communications over economical Ethernet media. For
more information, see www.modbus.org.
In the Vertex M this interface is always a server, never a client. More information on the
ABC4011 Communicator which is used in the Vertex M is available at www.anybus.com.
Vertex M 239 User Manual