unauthorized) being made to the monitor. Provide only the minimum access necessary to each
user.
Unfortunately, Chemcassette™ installation inherently requires interrupting monitoring and
requires human intervention. The Vertex M can be set up to issue a fault if this intervention is
not performed promptly. See "Configuration Utility" on page51 for more information.
However, for thorough protection against errors by personnel who are only authorized to install
Chemcassette™, many of the permission bits must be set to No. Specifically, bits A. E, F, I, J, L
and 0 bits set to No and bit B must be set to Yes. The TAPECHANGER account on the previous
page is an example of this.
Permission Codes
Vertex M 115 User Manual
To Next Page
Loading...
