Communications
Symptom Problem Recovery
Vertex M not appearing on network
Incorrect network connection
Check cable connection to Ethernet port
Note: Use only the Ethernet connection on the back of the data acquisition
computer. The Ethernet hub in the Vertex M system is only for Vertex M internal
use.
Windows not configured for network
Use Windows Network control panel to configure network
Vertex M computer name is Vertex_293-xxxx
Default workgroup is Workgroup
ChemCam
Symptom Problem Recovery
No image from one or more ChemCam
Defective camera Contact Honeywell
Defective USB port Use any other spare USB port
Poor image quality Camera settings are incorrect or illumination LED has failed Contact Honeywell
To Next Page
Loading...
