Honeywell Vigilon 4 loop

Message
associated with.. meaning.. ..possible action
Sector actioned LPC
(loop processor card)
Sector is switched ON/OFF. -
Sector enabled/
disabled at card x
LPC
(loop processor card)
The sector(s) has been enabled or disabled
automatically or manually.
If necessary, manually enable/disable the sector
using the [control] menu.
Seeking radio devices LRT Radio LRT is finding all of the radio devices -
Sensor faulty LPC
(loop processor card)
Wireless system - sensor head needs cleaning or
sensor head lost from a wireless base (wireless adaptor)
Also mean - Fault pattern has been matched.
Check and replace the sensor if necessary.
Sensor out of
specification
number x on Loop y
channel z
LPC
(loop processor card)
Fault pattern has been matched. Check and replace the sensor if necessary.
Sensor restored Radio (Plexus) Device A Radio (Plexus) Device head has been restored. -
Shared memory
hardware is faulty at
card x
Any Card There is MCC / MCB problem. Replace all other cards first other than the
MCC/MCB to see if the problem is resolved.
If it persists then replace MCC / MCB.
Slave Device
Replaced
number x on loop y
LPC
(loop processor card)
Slave type device has been replaced. -
Slave micro failed at
card x
LPC
(loop processor card)
Loop driver is watchdogged by loop processor. Reset and ignore single occurrence. Record in
the log book.
Software errors Software errors will activate
a system reset
Software error Software errors will activate a system reset.
Ignore single occurrence. Record the event in
the log book.
Sounder circuit
failed
Device There is a fault with the sounder hardware on the
S-Cubed or S-Quad.
Replace the device
Sounder circuit
Restored
Device The fault is on the sounder circuit associated with
S-Quad or S-Cubed has been restored.
-
Commissioning instructions
134 4188-856_issue 7_07/15_Generic Vigilon (Compact + VA) Comms.
Appendix B - Message Action List