Honeywell Vigilon 4 loop

Message
associated with.. meaning.. ..possible action
Speech circuit has
failed
Device There is a hardware fault possibly associated with the
voice chip on the speech S-Cubed or S-Quad
Replace the device
Speech circuit
Restored
Device The fault on the speech S-Quad and S-Cubed has been
restored.
-
Spurious
acknowledgment at
card x
Any Card Software error. Software errors will activate a system reset.
Ignore single occurrence. Record the event in
the log book.
Spurious FAB number x
on loop y
LPC
(loop processor card)
Device has FAB but shouldn’t have any. Ignore single occurrence as the panel will
remove the indication.
Stack overflow at
card x
Any Card Software error Software errors will activate a system reset
Ignore single occurrence. Record the event in
the log book
Stack too deep at
card x
Any Card Software error. Software errors will activate a system reset.
Ignore single occurrence. Record the event in
the log book.
Strobe circuit has
failed
Device The strobe circuit in the S-Quad or S-Cubed device has
failed.
Replace the device
Strobe circuit
restored
Device The strobe hardware fault, such as internal connection,
in the S-Cubed or S-Quad has been restored
-
Sub Faults See exceptions
Superfire number x on
loop y channel z
LPC
(loop processor card)
Pattern match is equal to or greater than a Fire. -
Supply totally Failed MCC / MCB
(main control card/board)
The message does not normally appear. -
Switching inhibited
at end 1 at card x
Network Automatic end swapping on the network controller has
been disabled for test purpose.
-
4188-856_issue 7_07/15_Generic Vigilon (Compact + VA) Comms. 135
Vigilon 4/6 loops & Compact (VA) panels & network nodes
Appendix B - Message Action List