HP 5920 Series Configuration Guide

131
Portal status: Enabled
Authentication type: Layer3
Portal Web server: newpt
Authentication domain: Not configured
Bas-ip: 20.20.20.1
User Detection: Not configured
Action for server detection:
Server type Server name Action
-- -- --
Layer3 source network:
IP address Mask
Destination authenticate subnet:
IP address Mask
IPv6:
Portal status: Disabled
Authentication type: Disabled
Portal Web server: Not configured
Authentication domain: Not configured
Bas-ipv6: Not configured
User detection: Not configured
Action for server detection:
Server type Server name Action
-- -- --
Layer3 source network:
IP address Prefix length
Destination authenticate subnet:
IP address Prefix length
Before a user performs portal authentication by using the HP iNode client, the user can access only the
authentication page http://192.168.0.111:8080/portal. All Web requests the user initiates will be
redirected to the authentication page. If the user passes the authentication but fails the security check, the
user can access only the resources that match ACL 3000. After passing both the authentication and the
security check, the user can access Internet resources that match ACL 3001.
After the user passes authentication, you can use the following command to display information about
the portal user.
[SwitchA] display portal user interface vlan-interface 4
Total portal users: 1
Username: abc
Portal server: newpt
State: Online
Authorization ACL: 3001
VPN instance: --
MAC IP VLAN Interface
0015-e9a6-7cfe 8.8.8.2 4 Vlan-interface4

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English