HP 5920 Series Configuration Guide

301
NOTE:
PSFTP supports only password authentication.
To establish a connection to the SFTP server:
a. Run the psftp.exe to launch the client interface shown in Figure 98, and enter the following
command:
open 192.168.1.45
b. Enter username client002 and password aabbcc as prompted to log in to the SFTP server.
Figure 98 SFTP client interface
Publickey authentication enabled SFTP client configuration
example
Network requirements
As shown in Figure 99, you can log in to Switch B through the SFTP client that runs on Switch A and are
assigned the user role network-admin to execute file management and transfer operations. Switch B acts
as the SFTP server and uses publickey authentication and the RSA public key algorithm.
Figure 99 Network diagram
Configuration procedure
In the server configuration, the client's host public key is required. Generate RSA key pairs on the client
before configuring the SFTP server.

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English