To Next Page

To Previous Page

335

Figure 113 Network diagram

Configuration procedure

1. Configure Switch A:

# Specify the IP address for Ten-GigabitEthernet 1/0/1.

<SwitchA> system-view

[SwitchA] interface ten-gigabitethernet 1/0/1

[SwitchA-Ten-GigabitEthernet1/0/1] port link-mode route

[SwitchA-Ten-GigabitEthernet1/0/1] ip address 10.1.1.1 24

[SwitchA-Ten-GigabitEthernet1/0/1] quit

# Configure DHCP.

[SwitchA] dhcp enable

[SwitchA] dhcp server ip-pool 1

[SwitchA-dhcp-pool-1] network 10.10.1.0 mask 255.255.255.0

[SwitchA-dhcp-pool-1] gateway-list 10.10.1.1

[SwitchA-dhcp-pool-1] quit

[SwitchA] ip route-static 10.10.1.0 24 10.1.1.2

2. Configure Switch B:

# Enable DHCP.

<SwitchB> system-view

[SwitchB] dhcp enable

# Specify the IP addresses of Ten-GigabitEthernet 1/0/1 and Ten-GigabitEthernet 1/0/2.

[SwitchB] interface ten-gigabitethernet 1/0/1

[SwitchB-Ten-GigabitEthernet1/0/1] port link-mode route

[SwitchB-Ten-GigabitEthernet1/0/1] ip address 10.1.1.2 24

[SwitchB-Ten-GigabitEthernet1/0/1] quit

[SwitchB] interface ten-gigabitethernet 1/0/2

[SwitchB-Ten-GigabitEthernet1/0/2] port link-mode route

[SwitchB-Ten-GigabitEthernet1/0/2] ip address 10.10.1.1 24

# Enable DHCP relay agent on Ten-GigabitEthernet 1/0/2.

[SwitchB-Ten-GigabitEthernet1/0/2] dhcp select relay

# Add the DHCP server 10.1.1.1 to DHCP server group 1.

[SwitchB-Ten-GigabitEthernet1/0/2] dhcp relay server-address 10.1.1.1

# Enable authorized ARP.

[SwitchB-Ten-GigabitEthernet1/0/2] arp authorized enable

[SwitchB-Ten-GigabitEthernet1/0/2] quit

HP 5920 Series Configuration Guide

Other manuals for HP 5920 Series