328
Displaying and maintaining unresolvable IP attack protection
Execute display commands in any view.
Task Command
Display ARP source suppression configuration information.
display arp source-suppression
Configuration example
Network requirements
As shown in Figure 110, a LAN contains two areas: an R&D area in VLAN 10 and an office area in VLAN
20. Each area connects to the gateway (Device) through an access switch.
A large number of ARP requests are detected in the office area and are considered as the consequence
of an unresolvable IP attack. To prevent the attack, configure ARP source suppression or ARP blackhole
routing.
Figure 110 Network diagram
Configuration considerations
If the attack packets have the same source address, configure the ARP source suppression function as
follows:
1. Enable ARP source suppression.
2. Set the threshold to 100. If the number of unresolvable IP packets received from a host within 5
seconds exceeds 100, the device stops resolving packets from the host until the 5 seconds elapse.
If the attack packets have different source addresses, enable the ARP blackhole routing function on the
gateway.
To Next Page
Loading...
Need help?
General
