HP 5920 Series Configuration Guide

294
e. Select Connection > SSH > Auth from the navigation tree.
The window shown in Figure 94 appears.
f. Cli
ck Browse… to bring up the file selection window, navigate to the private key file
(private.ppk in this example), and click OK.
Figure 94 Specifying the private key file
g. Click Open to connect to the server.
If the connection is successfully established, the system asks you to enter the username. After
entering the username (client002), you can enter the CLI of the server.
Password authentication enabled Stelnet client configuration
example
Network requirements
As shown in Figure 95, you can log in to Switch B through the Stelnet client that runs on Switch A and are
assigned the user role network-admin for configuration management. Switch B acts as the Stelnet server
and uses password authentication. The username and password of the client are saved on Switch B.
Figure 95 Network diagram

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English