EasyManuals Logo

HP 5920 Series Configuration Guide

HP 5920 Series
424 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #111 background imageLoading...
Page #111 background image
100
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Configure an IPv6
portal authentication
destination subnet.
portal ipv6 free-all except destination
ipv6-network-address prefix-length
By default, no IPv6 portal
authentication destination subnet is
configured, and users accessing any
subnets must pass portal
authentication.
Setting the maximum number of portal users
Perform this task to control the total number of portal users allowed in the system.
If you configure the maximum total number smaller than the number of current online portal users on the
device, this configuration still takes effect. The online users are not affected but the system forbids new
portal users to log in.
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Set the maximum number of
total portal users.
portal max-user max-number
By default, no limit is set on the
number of portal users in the system.
Specifying a portal authentication domain
An authentication domain defines a set of authentication, authorization, and accounting policies. Each
portal user belongs to an authentication domain and is authenticated, authorized, and accounted in the
domain.
After you specify a portal authentication domain on an interface, the device uses the specified
authentication domain for AAA of all portal users on the interface, ignoring the domain names carried
in the usernames. This allows for flexible portal access control.
The device selects the authentication domain for a portal user on an interface in this order:
1. ISP domain specified for the interface.
2. ISP domain carried in the username.
3. System default ISP domain. For information about the default ISP domain, see "Configuring AAA."
Y
ou can specify an IPv4 portal authentication domain, an IPv6 portal authentication domain, or both on
an interface.
To specify an IPv4 portal authentication domain:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A

Table of Contents

Other manuals for HP 5920 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 5920 Series and is the answer not in the manual?

HP 5920 Series Specifications

General IconGeneral
BrandHP
Model5920 Series
CategorySwitch
LanguageEnglish

Related product manuals