HP 5920 Series Configuration Guide

83
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet interface
view.
interface interface-type
interface-number
N/A
3. Set the maximum number of
concurrent MAC authentication
users on the port
mac-authentication max-user
user-number
By default, the maximum number
of concurrent MAC
authentication users on a port is
2048.
Configuring MAC authentication delay
When both 802.1X authentication and MAC authentication are enabled on a port, you can delay MAC
authentication so that 802.1X authentication is preferentially triggered.
If no 802.1X authentication is triggered or 802.1X authentication fails within the delay period, the port
continues to process MAC authentication.
Do not set the port security mode to mac-else-userlogin-secure or mac-else-userlogin-secure-ext when
you use MAC authentication delay. The delay does not take effect on a port in either of the two modes.
For more information about port security modes, see "Configuring port security."
T
o
configure MAC authentication delay:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet
interface view.
interface interface-type
interface-number
N/A
3. Enable MAC authentication
delay and set the delay timer.
mac-authentication timer
auth-delay time
By default, MAC authentication
delay is disabled.
Displaying and maintaining MAC authentication
Execute display commands in any view and reset commands in user view.
Task Command
Display MAC authentication information.
display mac-authentication [ interface interface-type
interface-number ]
Clear MAC authentication statistics.
reset mac-authentication statistics [ interface interface-type
interface-number ]

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English