HP 5920 Series Configuration Guide

81
Ste
p
Command Remarks
3. Enter Layer 2 Ethernet interface
view.
interface interface-type
interface-number
N/A
4. Enable MAC authentication on
the port.
mac-authentication
By default, MAC authentication is
disabled on a port.
Specifying a MAC authentication domain
By default, MAC authentication users are in the system default authentication domain. To implement
different access policies for users, you can specify authentication domains for MAC authentication users
in the following ways:
• Specify a global authentication domain in system view. This domain setting applies to all ports
enabled with MAC authentication.
• Specify an authentication domain for an individual port in Layer 2 Ethernet interface view.
MAC authentication chooses an authentication domain for users on a port in this order: the port-specific
domain, the global domain, and the default domain. For more information about authentication
domains, see "Configuring AAA."
T
o specify an authentication domain for MAC authentication users:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Specify an authentication
domain for MAC
authentication users.
• In system view:
mac-authentication domain
domain-name
• In Layer 2 Ethernet interface view:
a. interface interface-type
interface-number
b. mac-authentication domain
domain-name
Use either method.
By default, the system default
authentication domain is used for
MAC authentication users.
Configuring the user account format
To configure the MAC authentication user account format:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English