EasyManuals Logo

HP 5920 Series Configuration Guide

HP 5920 Series
424 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #110 background imageLoading...
Page #110 background image
99
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure an IPv4 portal
authentication source subnet.
portal layer3 source
ipv4-network-address
{ mask-length | mask }
By default, no IPv4 portal
authentication source subnet is
configured, and users from any
subnets must pass portal
authentication.
To configure an IPv6 portal authentication source subnet:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure an IPv6 portal
authentication source subnet.
portal ipv6 layer3 source
ipv6-network-address prefix-length
By default, no IPv6 portal
authentication source subnet is
configured, and IPv6 users from
any subnets must pass portal
authentication.
Configuring an authentication destination subnet
By configuring authentication destination subnets, you specify that users trigger portal authentication
only when they accessing the specified subnets (excluding the destination IP addresses and subnets
specified in portal-free rules). Users can access other subnets without portal authentication.
If both authentication source subnets and destination subnets are configured on an interface, only the
authentication destination subnets take effect.
You can configure multiple authentication destination subnets. If the destination subnets overlap, the
subnet with the largest address scope (with the smallest mask or prefix) takes effect.
To configure an IPv4 portal authentication destination subnet:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Configure an IPv4
portal authentication
destination subnet.
portal free-all except destination
ipv4-network-address { mask-length |
mask }
By default, no IPv4 portal
authentication destination subnet is
configured, and users accessing any
subnets must pass portal
authentication.
To configure an IPv6 portal authentication destination subnet:

Table of Contents

Other manuals for HP 5920 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 5920 Series and is the answer not in the manual?

HP 5920 Series Specifications

General IconGeneral
BrandHP
Model5920 Series
CategorySwitch
LanguageEnglish

Related product manuals