HP 5920 Series Configuration Guide

240
Configuring SNMP notifications for IPsec
After you enable SNMP notifications for IPsec, the IPsec module notifies the NMS of important module
events. The notifications are sent to the device's SNMP module. You can configure the notification
transmission parameters for the SNMP module to specify how the SNMP module displays notifications.
For more information about SNMP notifications, see Network Management and Monitoring
Configuration Guide.
To generate and output SNMP notifications for IPsec for a specific failure or event type, enable SNMP
notifications for IPsec globally and for the specified failure or event type.
To configure SNMP notifications for IPsec:
Ste
p
Command Remarks
1. Enter system view
system-view N/A
2. Enable SNMP notifications
for IPsec globally.
snmp-agent trap enable ipsec global
By default, SNMP notifications for
IPsec are disabled.
3. Enable SNMP notifications
for the specified failure or
event type.
snmp-agent trap enable ipsec
[ auth-failure | decrypt-failure |
encrypt-failure | invalid-sa-failure |
no-sa-failure | policy-add |
policy-attach | policy-delete |
policy-detach | tunnel-start |
tunnel-stop ] *
By default, SNMP notifications for
all failure and event types are
disabled.
Displaying and maintaining IPsec
Execute display commands in any view and reset commands in user view.
Task Command
Display IPsec policy information.
display ipsec { ipv6-policy | policy } [ policy-name
[ seq-number ] ]
Display IPsec policy template information.
display ipsec { ipv6-policy-template | policy-template }
[ template-name [ seq-number ] ]
Display IPsec profile information. display ipsec profile [ profile-name ]
Display IPsec transform set information. display ipsec transform-set [ transform-set-name ]
Display IPsec SA information.
display ipsec sa [ brief | count | interface interface-type
interface-number | { ipv6-policy | policy } policy-name
[ seq-number ] | profile policy-name | remote [ ipv6 ]
ip-address ]
Display IPsec statistics. display ipsec statistics [ tunnel-id tunnel-id ]
Display IPsec tunnel information. display ipsec tunnel { brief | count | tunnel-id tunnel-id }
Clear IPsec SAs.
reset ipsec sa [ { ipv6-policy | policy } policy-name
[ seq-number ] | profile policy-name | remote
{ ipv4-address | ipv6 ipv6-address } | spi { ipv4-address |
ipv6 ipv6-address } { ah | esp } spi-num ]

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English