398
Configuring Hub 2
1. Configure IP addresses for the interfaces. (Details not shown.)
2. Configure the VAM client:
# Create VAM client Hub2Group0.
<Hub2> system-view
[Hub2] vam client name Hub2Group0
# Specify ADVPN domain abc for the VAM client.
[Hub2-vam-client-Hub2Group0] advpn-domain abc
# Set the pre-shared key to 123456.
[Hub2-vam-client-Hub2Group0] pre-shared-key simple 123456
# Set both the username and password to hub2.
[Hub2-vam-client-Hub2Group0] user hub2 password simple hub2
# Specify the primary and secondary VAM servers.
[Hub2-vam-client-Hub2Group0] server primary ipv6-address 1::11
[Hub2-vam-client-Hub2Group0] server secondary ipv6-address 1::12
# Enable the VAM client.
[Hub2-vam-client-Hub2Group0] client enable
[Hub2-vam-client-Hub2Group0] quit
# Create VAM client Hub2Group1.
[Hub2] vam client name Hub2Group1
# Specify ADVPN domain abc for the VAM client.
[Hub2-vam-client-Hub2Group1] advpn-domain abc
# Set the pre-shared key to 123456.
[Hub2-vam-client-Hub2Group1] pre-shared-key simple 123456
# Set both the username and password to hub2.
[Hub2-vam-client-Hub2Group1] user Hub2 password simple Hub2
# Specify the primary and secondary VAM servers.
[Hub2-vam-client-Hub2Group1] server primary ipv6-address 1::11
[Hub2-vam-client-Hub2Group1] server secondary ipv6-address 1::12
# Enable the VAM client.
[Hub2-vam-client-Hub2Group1] client enable
[Hub2-vam-client-Hub2Group1] quit
3. Configure an IPsec profile:
# Configure IKE.
[Hub2] ike keychain abc
[Hub2-ike-keychain-abc] pre-shared-key address :: 0 key simple 123456
[Hub2-ike-keychain-abc] quit
[Hub2] ike profile abc
[Hub2-ike-profile-abc] keychain abc
[Hub2-ike-profile-abc] quit
# Configure the IPsec profile.
[Hub2] ipsec transform-set abc
[Hub2-ipsec-transform-set-abc] encapsulation-mode transport
[Hub2-ipsec-transform-set-abc] esp encryption-algorithm des-cbc
[Hub2-ipsec-transform-set-abc] esp authentication-algorithm sha1
[Hub2-ipsec-transform-set-abc] quit
To Next Page
Loading...
