EasyManuals Logo

HP FlexNetwork MSR2003 User Manual

HP FlexNetwork MSR2003
517 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #424 background imageLoading...
Page #424 background image
410
[PrimaryServer-vam-server-domain-abc-hub-group-0] hub private-address 192.168.0.1
public-address 1.0.0.1 advpn-port 4001
[PrimaryServer-vam-server-domain-abc-hub-group-0] hub private-address 192.168.0.2
public-address 1.0.0.1 advpn-port 4002
# Specify a spoke private IPv4 network.
[PrimaryServer-vam-server-domain-abc-hub-group-0] spoke private-address network
192.168.0.0 255.255.255.0
[PrimaryServer-vam-server-domain-abc-hub-group-0] quit
# Set the pre-shared key to 123456.
[PrimaryServer-vam-server-domain-abc] pre-shared-key simple 123456
# Set the authentication mode to CHAP.
[PrimaryServer-vam-server-domain-abc] authentication-method chap
# Enable the VAM server for the ADVPN domain.
[PrimaryServer-vam-server-domain-abc] server enable
[PrimaryServer-vam-server-domain-abc] quit
# Configure a default route.
[PrimaryServer] ip route-static 0.0.0.0 0 10.0.0.1
Configuring the secondary VAM server
# Configure the secondary VAM server in the same way that the primary server is configured.
(Details not shown.)
Configuring Hub 1
1. Configure IP addresses for the interfaces. (Details not shown.)
2. Configure the VAM client:
# Create VAM client Hub1.
<Hub1> system-view
[Hub1] vam client name Hub1
# Specify ADVPN domain abc for the VAM client.
[Hub1-vam-client-Hub1] advpn-domain abc
# Set the pre-shared key to 123456.
[Hub1-vam-client-Hub1] pre-shared-key simple 123456
# Set both the username and password to hub1.
[Hub1-vam-client-Hub1] user hub1 password simple hub1
# Specify the primary VAM server IP address as 1.0.0.4 (after NAT) and the port number as
4001 (after NAT).
[Hub1-vam-client-Hub1] server primary ip-address 1.0.0.4 port 4001
# Specify the secondary VAM server IP address as 1.0.0.4 (after NAT) and the port number as
4002 (after NAT).
[Hub1-vam-client-Hub1] server secondary ip-address 1.0.0.4 port 4002
# Enable the VAM client.
[Hub1-vam-client-Hub1] client enable
[Hub1-vam-client-Hub1] quit
3. Configure OSPF:
# Configure OSPF to advertise the private network.
[Hub1] ospf 1
[Hub1-ospf-1] area 0
[Hub1-ospf-1-area-0.0.0.0] network 192.168.0.0 0.0.0.255
[Hub1-ospf-1-area-0.0.0.0] quit

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP FlexNetwork MSR2003 and is the answer not in the manual?

HP FlexNetwork MSR2003 Specifications

General IconGeneral
BrandHP
ModelFlexNetwork MSR2003
CategoryNetwork Router
LanguageEnglish

Related product manuals