HP FlexNetwork MSR2003

457
IPv6-to-IPv4 source address translation policy
configuration, 435
N
AT configuration, 123, 129, 140
N
AT configuration
(bidirectional/external-internal access/domain
name), 153
N
AT configuration (dynamic inbound), 133
N
AT configuration (dynamic outbound), 132
N
AT configuration (dynamic
outbound/non-overlapping addresses), 141
N
AT configuration (dynamic), 131
N
AT configuration (outbound
bidirectional), 144
N
AT configuration (static inbound 1\1), 130
N
AT configuration (static inbound
net-to-net), 131
N
AT configuration (static outbound
1\1), 129, 140
N
AT configuration (static outbound
net-to-net), 130
N
AT configuration (static), 129
NA
T hairpin, 137
N
AT hairpin configuration (C/S mode), 156
N
AT hairpin configuration (P2P mode), 159
N
AT server configuration (external-internal
access), 147
N
AT server configuration (external-internal
access/domain name), 150
N
AT server configuration (load sharing), 165
N
AT translation control, 124
N
AT+DNS mapping configuration, 167
NA
T444 configuration (DS-Lite), 170
spec
ial IP addresses, 25
stateles
s DHCPv6, 238
t
wice NAT configuration, 162
address famil
y
AFT configuration, 429
AF
T enabling, 434
AFT
prefix translation, 430
address p
refix translation
AFT prefix, 430
Addre
ss Resolution Protocol. Use ARP
adja
cency table
adjacency table command and hardware
compatibility, 181
displa
y, 180
displa
ying commands, 181
advertisi
ng
ARP direct route advertisement configuration, 23
I
P services IRDP proxy-advertised IP address, 182
I
P services IRDP router advertisement (RA), 182
ADVPN
AAA co
nfiguration, 337
c
onfiguration, 332, 337, 349
connec
tion initialization, 334
displa
y, 347
domain c
reation, 338
h
ub group configuration, 339
h
ub group creation, 339
h
ub group hub private address, 339
h
ub group spoke private address range, 339
I
Pv4 full-mesh configuration, 349
I
Pv4 full-mesh NAT traversal configuration, 408
I
Pv4 hub-spoke configuration, 364
I
Pv4 multi-hub-group configuration, 379
I
Pv6 full-mesh configuration, 356
I
Pv6 hub-spoke configuration, 372
I
Pv6 multi-hub-group configuration, 393
main
tain, 347
NA
T traversal, 337
oper
ation, 334
pac
ket forwarding, 336
re
gistration, 335
r
oute learning, 336
ro
uting configuration, 347
spec
ifying ACL to control establishing
spoke-to-spoke tunnel, 340
str
ucture, 332
tunnel e
stablishment, 335
tunnel in
terface configuration, 345
tunnel IP
sec configuration, 347
V
AM client configuration, 342
V
AM client creation, 343
V
AM client domain, 343
V
AM client dumb timer, 344
V
AM client enable, 343
V
AM client pre-shared key, 344
V
AM client retry timer/times, 344
V
AM client server configuration, 343
VA
M client username+password, 345
V
AM server authentication algorithm, 341
V
AM server authentication method, 341