Configuration Menu 106
HTTPS Access configuration
Command: /cfg/sys/access/https
[https Menu]
access - Enable/Disable HTTPS Web access
port - HTTPS WebServer port number
generate - Generate self-signed HTTPS server certificate
certSave - save HTTPS certificate
cur - Display current SSL Web Access configuration
The following table describes the HTTPS Access Configuration Menu options.
Table 98 HTTPS Access Configuration Menu options
Command Description
access enable|disable Enables or disables BBI access (Web access) using HTTPS. The default value is
disabled.
port <TCP port number> Defines the HTTPS Web server port number.
generate Allows you to generate a certificate to connect to the SSL to be used during the key
exchange. A default certificate is created when HTTPS is enabled for the first time. The
user can create a new certificate defining the information that they want to be used in
the various fields. For example:
• Country Name (2 letter code) [ ]: CA
• State or Province Name (full name) [ ]: Ontario
• Locality Name (for example, city) [ ]: Ottawa
• Organization Name (for example, company) [ ]: Hewlett-Packard
• Organizational Unit Name (for example, section) [ ]: ProLiant
• Common Name (for example, user’s name) [ ]: Mr Smith
• Email (for example, email address) [ ]: info@hp.com
You must confirm if you want to generate the certificate. It takes approximately
30 seconds to generate the certificate. Then the switch restarts SSL agent.
certSave Allows the client, or the Web browser, to accept the certificate and save the certificate
to Flash to be used when the switch is rebooted.
cur Displays the current SSL Web Access configuration.
Port configuration
Command: /cfg/port <port number>
[Port 1 Menu]
gig - Gig Phy Menu
aclqos - Acl/Qos Configuration Menu
8021ppri - Set default 802.1p priority
pvid - Set default port VLAN id
name - Set port name
rmon - Enable/Disable RMON for port
tag - Enable/disable VLAN tagging for port
tagpvid - Enable/disable tagging on pvid
media - Current media copper/fiber
fiber - Set fiber
copper - Set copper
automedia - Set Auto
brate - Set BroadCast Threshold
mrate - Set MultiCast Threshold
drate - Set Dest. Lookup Fail Threshold
ena - Enable port
dis - Disable port
cur - Display current port configuration
This menu enables you to configure settings for individual switch ports. This command is enabled by default.
NOTE: Port 19 is reserved for switch management.
The following table describes the Port Configuration Menu options.
To Next Page
Loading...
