HP GbE2c - Blc Layer 2/3 Fiber SFP Option - Route Information

Information Menu 44
The following table describes the Layer 3 Information Menu options.
Table 26 Layer 3 information menu options
Command Usage
route
Displays the IP Routing Menu. Using the options of this menu, the system displays the following for
each configured or learned route:
• Route destination IP address, subnet mask, and gateway address
• Type of route
• Tag indicating origin of route
• Metric for RIP tagged routes, specifying the number of hops to the destination (1-15 hops, or
16 for infinite hops)
• The IP interface that the route uses
arp
Displays the Address Resolution Protocol (ARP) Information Menu.
*ospf
Displays OSPF routing Information Menu.
*rip
Displays Routing Information Protocol Menu.
ip
Displays IP Information. IP information, includes:
• IP interface information: Interface number, IP address, subnet mask, VLAN number, and
operational status.
• Default gateway information: Metric for selecting which configured gateway to use, gateway
number, IP address, and health status
• IP forwarding information: Enable status, lnet and lmask
• Port status
igmp
Displays IGMP Information Menu.
*vrrp
Displays the VRRP Information Menu.
dump
Dumps all switch information available from the Layer 3 Menu (10K or more, depending on your
configuration).
If you want to capture dump data to a file, set your communication software on your workstation
to capture session data prior to issuing the dump commands.
* indicates menus that are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
Route information
Command: /info/l3/route
[IP Routing Menu]
find - Show a single route by destination IP address
gw - Show routes to a single gateway
type - Show routes of a single type
tag - Show routes of a single tag
if - Show routes on a single interface
dump - Show all routes
Using the commands listed below, you can display all or a portion of the IP routes currently held in the switch.
Table 27 Route Information menu options
Command Usage
find <IP address>
Displays a single route by IP address. For example,
100.10.1.1
gw <IP address>
Displays routes to a single gateway. For example,
100.10.1.2
type indirect|direct|local|
broadcast|martian|multicast
Displays routes of a single type.
tag fixed|static|addr|rip|ospf|
broadcast|martian|multicast
Displays routes of a single tag.
if <IP address>
Displays routes on a single interface.
dump
Displays all routes configured in the switch.