HP GbE2c - Blc Layer 2/3 Fiber SFP Option - OSPF Route Codes Information; Routing Information Protocol Information; RIP Routes Information

Information Menu 50
OSPF route codes information
NOTE: OSPF commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
Command: /info/l3/ospf/routes
Codes: IA - OSPF inter area,
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
IA 10.10.0.0/16 via 200.1.1.2
IA 40.1.1.0/28 via 20.1.1.2
IA 80.1.1.0/24 via 200.1.1.2
IA 100.1.1.0/24 via 20.1.1.2
IA 140.1.1.0/27 via 20.1.1.2
IA 150.1.1.0/28 via 200.1.1.2
E2 172.18.1.1/32 via 30.1.1.2
E2 172.18.1.2/32 via 30.1.1.2
E2 172.18.1.3/32 via 30.1.1.2
E2 172.18.1.4/32 via 30.1.1.2
E2 172.18.1.5/32 via 30.1.1.2
E2 172.18.1.6/32 via 30.1.1.2
E2 172.18.1.7/32 via 30.1.1.2
E2 172.18.1.8/32 via 30.1.1.2
Routing Information Protocol information
Command: /info/l3/rip
[RIP Information Menu]
routes - Show RIP routes
dump - Show RIP user's configuration
NOTE: This menu is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The following table describes the Routing Information Protocol information menu options.
Table 34 RIP information
Command Usage
routes
Displays information about RIP routes.
dump <0-255>
Displays RIP user’s configuration. Enter 0 (zero) for all
interfaces.
RIP Routes information
NOTE: RIP commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
Command: /info/l3/rip/routes
>> IP Routing# /info/l3/rip/routes
3.0.0.0/8 via 30.1.1.11 metric 4
4.0.0.0/16 via 30.1.1.11 metric 16
10.0.0.0/8 via 30.1.1.2 metric 3
20.0.0.0/8 via 30.1.1.2 metric 2
This table contains all dynamic routes learned through RIP, including the routes that are undergoing garbage
collection with metric = 16. This table does not contain directly connected routes and locally configured static routes.