HP GbE2c - Blc Layer 2/3 Fiber SFP Option - IP Access List Configuration; Autonomous System Path Configuration

Configuration Menu 127
Table 128 Route Map Configuration Menu options
Command Description
enable
Enables the route map.
disable
Disables the route map.
delete
Deletes the route map.
cur Displays the current route configuration.
IP Access List configuration
Command: /cfg/l3/rmap <1-32>/alist <1-8>
[IP Access List 1 Menu]
nwf - Network Filter number
metric - Metric
action - Set Network Filter action
enable - Enable Access List
disable - Disable Access List
delete - Delete Access List
current - Display current Access List configuration
NOTE: This menu is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The route map number (1-32) and the access list number (1-8) represent the IP access list you wish to configure. The
following table describes the IP Access List Configuration Menu options.
Table 129 IP Access List Configuration Menu options
Command Description
nwf <1-256>
Sets the network filter number.
metric <1-4294967294>|none
Sets the metric value in the AS-External (ASE) LSA.
action permit|deny
Permits or denies action for the access list.
enable
Enables the access list.
disable
Disables the access list.
delete
Deletes the access list.
cur Displays the current Access List configuration.
Autonomous System Path configuration
Command: /cfg/l3/rmap <1-32>/aspath <1-8>
[AS Filter 1 Menu]
as - AS number
action - Set AS Filter action
enable - Enable AS Filter
disable - Disable AS Filter
delete - Delete AS Filter
current - Display current AS Filter configuration
NOTE: This menu is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.