HP GbE2c - Blc Layer 2/3 Fiber SFP Option - IP Trunk Hash Configuration; Layer 2 IP Trunk Hash Configuration; Link Aggregation Control Protocol Configuration

Configuration Menu 120
IP Trunk Hash configuration
Command: /cfg/l2/thash
[IP Trunk Hash Menu]
set - IP Trunk Hash Settings Menu
cur - Display current IP trunk hash configuration
The following table describes the IP Trunk Hash Configuration Menu options.
Table 116 IP Trunk Hash Configuration Menu options
Command Description
set
Displays the Trunk Hash Settings menu.
cur Display current trunk hash configuration.
Layer 2 IP Trunk Hash configuration
Command: /cfg/l2/thash/set
[set IP Trunk Hash Settings Menu]
smac - Enable/disable smac hash
dmac - Enable/disable dmac hash
sip - Enable/disable sip hash
dip - Enable/disable dip hash
cur - Display current trunk hash setting
Trunk hash parameters are set globally for the GbE2c. You can enable one or two parameters, to configure any of
the following valid combinations:
• SMAC (source MAC only)
• DMAC (destination MAC only)
• SIP (source IP only)
• DIP (destination IP only)
• SIP + DIP (source IP and destination IP)
• SMAC + DMAC (source MAC and destination MAC)
The following table describes the IP Trunk Hash Configuration Menu options.
Table 117 IP Trunk Hash Set Menu options
Command Description
smac enable|disable
Enable or disable trunk hashing on the source MAC.
dmac enable|disable
Enable or disable trunk hashing on the destination MAC.
sip enable|disable
Enable or disable trunk hashing on the source IP.
dip enable|disable
Enable or disable trunk hashing on the destination IP.
cur Display current trunk hash configuration.
Link Aggregation Control Protocol configuration
Command: /cfg/l2/lacp
[LACP Menu]
sysprio - Set LACP system priority
timeout - Set LACP system timeout scale for timing out partner info
port - LACP port Menu
cur - Display current LACP configuration