Configuration Menu 110
[802.1x Configuration Menu]
global - Global 802.1x configuration menu
port - Port 802.1x configuration menu
ena - Enable 802.1x access control
dis - Disable 802.1x access control
cur - Show 802.1x configuration
This feature allows you to configure the GbE2c as an IEEE 802.1x Authenticator, to provide port-based network
access control. The following table describes the 802.1x Configuration Menu options.
Table 103 802.1x Configuration Menu options
Command Description
global Displays the global 802.1x Configuration Menu.
port <port number>
Displays the 802.1x Port Menu.
ena Globally enables 802.1x.
dis Globally disables 802.1x.
cur Displays current 802.1x parameters.
802.1x Global configuration
Command: /cfg/l2/8021x/global
[802.1x Global Configuration Menu]
mode - Set access control mode
qtperiod - Set EAP-Request/Identity quiet time interval
txperiod - Set EAP-Request/Identity retransmission timeout
suptmout - Set EAP-Request retransmission timeout
svrtmout - Set server authentication request timeout
maxreq - Set max number of EAP-Request retransmissions
raperiod - Set reauthentication time interval
reauth - Set reauthentication status to on or off
default - Restore default 802.1x configuration
cur - Display current 802.1x configuration
The global 802.1x menu allows you to configure parameters that affect all ports in the switch. The following table
describes the 802.1x Global Configuration Menu options.
Table 104 802.1x Global Configuration Menu options
Command Description
mode force-
unauth|auto|force-auth
Sets the type of access control for all ports:
• force-unauth - the port is unauthorized unconditionally.
• auto - the port is unauthorized until it is successfully authorized by the
RADIUS server.
• force-auth - the port is authorized unconditionally, allowing all traffic.
The default value is
force-auth.
qtperiod <0-65535>
Sets the time, in seconds, the authenticator waits before transmitting an EAP-
Request/ Identity frame to the supplicant (client) after an authentication failure
in the previous round of authentication. The default value is 60 seconds.
txperiod <1-65535>
Sets the time, in seconds, the authenticator waits for an EAP-Response/Identity
frame from the supplicant (client) before retransmitting an EAP-Request/Identity
frame. The default value is 30 seconds.
suptmout <1-65535>
Sets the time, in seconds, the authenticator waits for an EAP-Response packet
from the supplicant (client) before retransmitting the EAP-Request packet to the
authentication server. The default value is 30 seconds.
svrtmout <1-65535>
Sets the time, in seconds, the authenticator waits for a response from the Radius
server before declaring an authentication timeout. The default value is 30
seconds.
The time interval between transmissions of the RADIUS Access-Request packet
containing the supplicant’s (client’s) EAP-Response packet is determined by the
current setting of
/cfg/sys/radius/timeout (default is 3 seconds).
To Next Page
Loading...
