HP GbE2c - Blc Layer 2/3 Fiber SFP Option - Port Acl;Qos Configuration; Layer 2 Configuration; 802.1 X Configuration

Configuration Menu 109
Port ACL/QoS configuration
Command: /cfg/port <port number>/aclqos
[Port 20 ACL Menu]
add - Add ACL or ACL group to this port
rem - Remove ACL or ACL group from this port
cur - Display current ACLs for this port
The following table describes the port ACL/QoS Configuration Menu options.
Table 101 Port ACL/QoS Configuration Menu options
Command Description
add acl <1-762>| grp <1-762> Assigns an ACL or ACL Group to the port.
rem acl <1-762>| grp <1-762> Removes an ACL or ACL Group from the port.
cur Displays current port ACL/QoS parameters.
Layer 2 configuration
Command: /cfg/l2
[Layer 2 Menu]
8021x - 802.1x Menu
mrst - Multiple Spanning Tree/Rapid Spanning Tree Menu
stp - Spanning Tree Menu
fdb - FDB Menu
trunk - Trunk Group Menu
thash - IP Trunk Hash Menu
lacp - Link Aggregation Control Protocol Menu
vlan - VLAN Menu
upfast - Enable/disable Uplink Fast
update - UplinkFast station update rate
cur - Display current layer 2 parameters
The following table describes the Layer 2 Configuration Menu options.
Table 102 L2 Configuration Menu options
Command Description
8021x Displays the 802.1x Configuration Menu.
mrst Displays the Rapid Spanning Tree/Multiple Spanning Tree Protocol Configuration Menu.
stp Displays the Spanning Tree Configuration Menu.
fdb Displays the Forwarding Database Configuration Menu.
trunk <1-12> Displays the Trunk Group Configuration Menu for the selected trunk (1-12).
thash Displays the IP Trunk Hash Menu.
lacp Displays the Link Aggregation Control Protocol Menu.
vlan <1-4095>
Displays the VLAN Configuration Menu.
upfast enable|disable
Enables or disables Fast Uplink Convergence, which provides rapid Spanning Tree
convergence to an upstream switch during failover.
Note: When enabled, this feature increases bridge priorities to 65500 for all STGs and
path cost by 3000 for all external STP ports.
update <10-200>
Configures the station update rate, in packets per second.
The range is 10-200. The default value is 40.
cur Displays current Layer 2 parameters.
802.1x configuration
Command: /cfg/l2/8021x