HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Guide

Configuration Menu 128
The rmap number (1-32) and the path number (1-8) represent the AS path you wish to configure. The following table
describes the Autonomous System Path Configuration Menu options.
Table 130 Autonomous System Path Configuration Menu options
Command Description
as <1-65535>
Sets the Autonomous System filter’s path number.
action permit|deny
Permits or denies Autonomous System filter action.
enable
Enables the Autonomous System filter.
disable
Disables the Autonomous System filter.
delete
Deletes the Autonomous System filter.
cur Displays the current Autonomous System filter configuration.
Routing Information Protocol configuration
Command: /cfg/l3/rip
[Routing Information Protocol Menu]
if - RIP Interface Menu
update - Set update period in seconds
redist - RIP Route Redistribute Menu
on - Globally turn RIP ON
off - Globally turn RIP OFF
current - Display current RIP configuration
NOTE: This menu is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The RIP Menu is used for configuring Routing Information Protocol parameters. This option is turned off by default.
The following table describes the RIP Configuration Menu options.
Table 131 RIP Configuration Menu options
Command Description
if <1-256>
Displays the RIP Interface menu.
update <1-120>
Configures the time interval for sending for RIP table updates, in seconds.
The default value is 30 seconds.
redist
Displays the RIP Route Redistribute menu.
on
Globally turns RIP on.
off
Globally turns RIP off.
cur Displays the current RIP configuration.

HP GbE2c - Blc Layer 2/3 Fiber SFP Option Specifications

General

Brand	HP
Model	GbE2c - Blc Layer 2/3 Fiber SFP Option
Category	Switch
Language	English