Configuration Menu 141
Virtual Router Redundancy Protocol configuration
Command: /cfg/l3/vrrp
[Virtual Router Redundancy Protocol Menu]
vr - VRRP Virtual Router Menu
group - VRRP Virtual Router Group Menu
if - VRRP Interface Menu
track - VRRP Priority Tracking Menu
on - Globally turn VRRP ON
off - Globally turn VRRP OFF
cur - Display current VRRP configuration
NOTE: This menu is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
Virtual Router Redundancy Protocol (VRRP) support on the GbE2c provides redundancy between routers in a LAN.
This is accomplished by configuring the same virtual router IP address and ID number on each participating VRRP-
capable routing device. One of the virtual routers is then elected as the master, based on a number of priority
criteria, and assumes control of the shared virtual router IP address. If the master fails, one of the backup virtual
routers will assume routing authority and take control of the virtual router IP address.
By default, VRRP is disabled. For more information on VRRP, see the “High Availability” chapter in the HP GbE2c
Ethernet Blade Switch for c-Class BladeSystem Application Guide.
The following table describes the VRRP Configuration Menu options.
Table 150 VRRP Configuration Menu options
Command Description
vr <1-255>
Displays the VRRP Virtual Router Menu. This menu is used for configuring up to
255 virtual routers on this switch.
group
Displays the VRRP virtual router group menu, used to combine all virtual routers
together as one logical entity. Group options must be configured when using
two or more GbE2c in a hot-standby failover configuration where only one
switch is active at any given time.
if <1-256>
Displays the VRRP Virtual Router Interface Menu.
track Displays the VRRP Tracking Menu. This menu is used for weighting the criteria
used when modifying priority levels in the master router election process.
on Globally enables VRRP on this switch.
off Globally disables VRRP on this switch.
cur Displays the current VRRP parameters.
VRRP Virtual Router configuration
Command: /cfg/l3/vrrp/vr <1-255>
[VRRP Virtual Router 1 Menu]
track - Priority Tracking Menu
vrid - Set virtual router ID
addr - Set IP address
if - Set interface number
prio - Set renter priority
adver - Set advertisement interval
preem - Enable/disable preemption
ena - Enable virtual router
dis - Disable virtual router
del - Delete virtual router
cur - Display current VRRP virtual router configuration
NOTE: This menu is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
This menu is used for configuring virtual routers for this switch. A virtual router is defined by its virtual router ID and
an IP address. On each VRRP-capable routing device participating in redundancy for this virtual router, a virtual
router will be configured to share the same virtual router ID and IP address.
To Next Page
Loading...
