Configuring the switch 138
Table 106 Port 802.1x Configuration controls
Control Description
Overwrite Configuration with Overwrites the port configuration settings with the global or default 802.1x settings.
FDB Configuration
To display the following form, select Layer 2 > FDB (click the underlined text, not the folder).
The following table describes the FDB Configuration controls:
Table 107 FDB Configuration controls
Control Description
Bridge Aging Time (0-65535 secs) Configures the forwarding database aging time. The aging time specifies the amount of
time the STP bridge waits without receiving a packet from a station before removing the
station from the forwarding database. The default is 180 seconds.
To disable aging, set this parameter to 0.
Static FDB Configuration (part one)
To display the following form, select Layer 2 > FDB >Static FDB (click the underlined text, not the folder).
This form summarizes the Static Forwarding Database entries. Select a static FDB ID number to display the Static
FDB Configuration form. Click Clear to clear the static FDB entries.
To Next Page
Loading...
Need help?
General