HP GbE2c - Blc Layer 2/3 Fiber SFP Option

Configuring the switch 190
RIP General Configuration
NOTE: This form is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
To display the following form, select Layer 3 > Routing Information Protocol > General.
The following table describes the RIP Interface Configuration controls:
Table 158 RIP General Configuration controls
Control Descriptions
Globally Enable RIP? Globally enables or disables RIP.
Update Period (1-120 sec) Configures the time interval for sending for RIP table updates, in seconds.
The default value is 30 seconds.
Virtual Routers Configuration
NOTE: This form is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
To display the following form, select Layer 3 > Virtual Router Redundancy Protocol > Virtual Routers (click the
underline text, not the folder).