HP GbE2c - Blc Layer 2/3 Fiber SFP Option

Configuring the switch 177
OSPF General Configuration
NOTE: This form is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
To display the following form, select Layer 3 > OSPF Routing Protocol > General.
The following table describes the OSPF General Configuration controls:
Table 145 OSPF General Configuration controls
Control Descriptions
Globally Enable OSPF? Enables or disables OSPF.
External LSDB Limit (0-2000) Sets the link state database limit. Enter zero (0) to indicate that there is no
limit.
Default Route Metric (1-16777215, 0=none) Sets one default route among multiple choices in an area.
Default Route Metric Type Sets the default-route metric type. Enter none to indicate that there is no
default.