Configuring the switch 167
Route Map Configuration
NOTE: This form is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
To display the following form, go to the Route Maps Configuration form. Select a route map ID number, or open
the Route Maps folder and click Add Route Map.
The following table describes the Route Map Configuration controls:
Table 136 Route Map Configuration controls
Control Description
Route Map Identifier (1-32) Assigns a numeric identifier to the route map.
Local Preference (1-4294967294 | none=4294967295) Sets the local preference of the matched route, which affects both
inbound and outbound directions. The path with the higher
preference is preferred.
Precedence (1-255) Sets the precedence of the route map. The smaller the value, the
higher the precedence. Default value is 10.
AS-Path Prepend of the Matched Route Sets the AS path preference of the matched route. One to three
path preferences can be configured.
Metric (1-4294967294 | none=4294967295) Sets the metric of the matched route.
Weight (0-65534 | none=65535) Sets the weight of the route map.
To Next Page
Loading...
