Configuring the switch 151
LACP Configuration
To display the following form, select Layer 2 > LACP.
The following table describes the Switch LACP Configuration controls:
Table 119 Switch LACP Configuration controls
Control Description
LACP System Priority (1-65535) Defines the priority value (1 through 65535) for the switch. Lower numbers provide
higher priority. The default value is 32768.
Timeout time Defines the timeout period before invalidating LACP data from a remote partner.
Choose
short (3 seconds) or long (90 seconds). The default value is long.
Note: HP recommends that you use a timeout value of
long, to reduce LACPDU
processing. If your switch’s CPU utilization rate remains at 100% for periods of 90
seconds or more, consider using static trunks instead of LACP.
To Next Page
Loading...
