HP GbE2c - Blc Layer 2/3 Fiber SFP Option User Manual

Configuring the switch 187
RIP Interfaces Configuration
NOTE: This form is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
To display the following form, select Layer 3 > Routing Information Protocol > Routing Information Protocol (click
the underlined text, not the folder).
RIP is used for configuring Routing Information Protocol parameters. This option is turned off by default.
NOTE: Do not configure RIP version 1 parameters if your routing equipment uses RIP version 2.
The following table describes the RIP Interfaces Configuration controls:
Table 155 RIP Interfaces Configuration controls
Control Description
Search Range To search for a RIP interface, enter a range of interface numbers in the From and To fields.
Search Options To focus the search for a VLAN, enter optional search parameters:
• RIP Version
• RIP state
Fields that have a value of “any” are ignored during the search.
Choose a search operation:
• or: Search for RIP interfaces specified in the search range that meet any of the criteria
entered.
• and: Search for RIP interfaces specified in the search range that meet all of the criteria
entered.
Click Search to display RIP interfaces that fit the range and meet the criteria entered.

HP GbE2c - Blc Layer 2/3 Fiber SFP Option Specifications

General

Brand	HP
Model	GbE2c - Blc Layer 2/3 Fiber SFP Option
Category	Switch
Language	English